Filter
Top Products
608 CHAPTER 17: 802.1X MANAGEMENT COMMANDS
See Also
display dot1x on page 599
set dot1x reauth-max on page 608
set dot1x reauth-period on page 609
set dot1x
reauth-max
Sets the number of reauthentication attempts that the WX switch makes
before the supplicant (client) becomes unauthorized.
Syntax —
set dot1x reauth-max number-of-attempts
number-of-attempts — Specify a value between 1 and 10.
Defaults — The default number of reauthentication attempts is 2.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If the number of reauthentications for a wired authentication
client is greater than the maximum number of reauthentications allowed,
MSS sends an EAP failure packet to the client and removes the client from
the network. However, MSS does not remove a wireless client from the
network under these circumstances.
Examples — Type the following command to set the number of
authentication attempts to 8:
WX4400# set dot1x reauth-max 8
success: dot1x max reauth set to 8.
See Also
display dot1x on page 599
clear dot1x reauth-max on page 597