Filter
Top Products
set ap radio auto-tune max- retransmissions 385
Defaults — The default maximum power setting that RF Auto-Tuning
can set on a radio is the highest setting allowed for the country of
operation or highest setting supported on the hardware, whichever is
lower.
Access — Enabled.
History —Introduced in MSS Version 3.0. Option auto added for
configuration of the MAP configuration profile.
Examples — The following command sets the maximum power that
RF Auto-Tuning can set on radio 1 on the MAP access point on port 6 to
12 dBm.
WX1200# set ap 7 radio 1 auto-tune max-power 12
success: change accepted.
See Also
set ap radio auto-tune max- retransmissions on page 385
set radio-profile auto-tune power-config on page 406
set radio-profile auto-tune power-interval on page 407
set ap radio
auto-tune max-
retransmissions
Sets the maximum percentage of client retransmissions a radio can
experience before RF Auto-Tuning considers changing the channel on the
radio. A high percentage of retransmissions is a symptom of interference
on the channel.
Syntax —
set {ap ap-number auto} radio {1 | 2} auto-tune
max-retransmissions retransmissions
ap ap-number — Index value that identifies the MAP on the WX..
ap auto — Sets the maximum retransmissions for radios configured
by the MAP configuration profile. (See set ap auto on page 362.)
radio 1 — Radio 1 of the MAP.
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
retransmissions — Percentage of packets that can result in
retransmissions without resulting in a channel change. You can specify
from 1 to 100.