Filter
Top Products
364 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
set ap blink on page 368
set ap group on page 379
set ap radio auto-tune max-power on page 384
set ap radio auto-tune max- retransmissions on page 385
set ap radio link-calibration on page 388
set ap radio mode on page 391
set ap radio radio-profile on page 392
set ap upgrade-firmware on page 396
set ap auto
persistent
Converts a temporary MAP configuration created by the MAP
configuration profile into a persistent MAP configuration on the WX.
Syntax —
set ap auto persistent [ap-number | all]
ap-number — Index value that identifies the MAP on the WX.
all — Converts the configurations of all Auto-APs being managed by
the switch into permanent configurations.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.0. Version 6.0 removed the dap option.
Usage — To display the Distributed MAP numbers assigned to
Auto-MAPs, use the display ap status auto command.
Examples — The following command converts the configuration of
Auto-AP 10 into a permanent configuration:
WX4400# set ap auto persistent 10
success: change accepted.
See Also
set ap auto on page 362
set ap auto mode on page 366
set ap auto radiotype on page 365