Filter
Top Products
set snoop mode 705
set snoop mode Enables a snoop filter. A snoop filter does not take effect until you map it
to a MAP radio and enable the filter.
Syntax —
set snoop {filter-name | all}
mode {enable [stop-after num-pkts] | disable}
filter-name | all — Name of the snoop filter. Specify all to enable
all snoop filters.
enable — Enables the snoop filter.
disable — Disables the snoop filter.
Defaults — Snoop filters are disabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.0. Version 6.0 removed the
stop-after
option. Also filter mode was made persistent across restarts.
Usage — The filter mode is retained even if you disable and reenable the
radio, or restart the MAP or the WX switch. Once the filter is enabled,
you must use the disable option to disable it.
Examples — The following command enables snoop filter snoop1:
WX# set snoop snoop1 mode enable
success: filter 'snoop1' enabled
See Also
display snoop on page 706
display snoop info on page 706
display snoop map on page 707
display snoop stats on page 708