Filter
Top Products
set ip ssh server 181
See Also
set ip ssh server on page 181
set ip ssh server Disables or reenables the SSH server on a WX.
CAUTION: If you disable the SSH server, SSH access to the WX is also
disabled.
Syntax —
set ip ssh server {enable | disable}
enable — Enables the SSH server.
disable — Disables the SSH server.
Defaults — The SSH server is enabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must generate an SSH authentication key to use SSH.
The maximum number of SSH sessions supported on a WX is eight. If
Telnet is also enabled, the WX can have up to eight Telnet or SSH
sessions, in any combination, and one Console session.
See Also
crypto generate key on page 565
set ip ssh on page 180
set ip ssh server on page 181
set ip telnet Changes the TCP port number on which a WX listens for Telnet
management traffic.
CAUTION: If you change the Telnet port number from a Telnet session,
MSS immediately ends the session. To open a new management session,
you must Telnet to the WX with the new Telnet port number.
Syntax —
set ip telnet port-num
port-num — TCP port number.