Filter
Top Products
286 CHAPTER 9: MOBILITY DOMAIN COMMANDS
set
mobility-domain
mode member
seed-ip
On a nonseed WX, sets the IP address of the seed WX. This command is
used on a member WX to configure it as a member. If the WX is currently
part of another Mobility Domain or using another seed, this command
overwrites that configuration.
Syntax —
set mobility-domain mode member seed-ip ip-addr key
hex-bytes
ip-addr — IP address of the Mobility Domain member, in dotted
decimal notation.
key hex-bytes — Fingerprint of the public key to use for WX-WX
security. Specify the key as 16 hexadecimal bytes. Use a colon
between each byte, as in the following example:
00:11:22:33:44:55:66:77:88:99:aa:bb:cc:dd:ee:ff.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 1.0. Option key hex-bytes added in
Version 5.0.
Examples — The following command sets the current WX as a nonseed
member of the Mobility Domain whose seed has the IP address
192.168.1.8:
WX# set mobility-domain mode member secondary seed-ip
192.168.1.8
See Also
clear mobility-domain on page 280
display mobility-domain config on page 282