Filter
Top Products
596 CHAPTER 17: 802.1X MANAGEMENT COMMANDS
Usage — This command is overridden by the set dot1x authcontrol
command. The clear dot1x port-control command returns port control
to the method configured. This command applies only to wired
authentication ports.
Examples — Type the following command to reset the wired
authentication port control:
WX4400# clear dot1x port-control
success: change accepted.
See Also
display dot1x on page 599
set dot1x port-control on page 606
clear dot1x
quiet-period
Resets the quiet period after a failed authentication to the default setting.
Syntax — clear dot1x quiet-period
Defaults — The default is 60 seconds.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — Type the following command to reset the 802.1X quiet
period to the default:
WX4400# clear dot1x quiet-period
success: change accepted.
See Also
display dot1x on page 599
set dot1x quiet-period on page 607