Filter
Top Products
142 CHAPTER 7: IP SERVICES COMMANDS
Examples — The following command removes NTP server
192.168.40.240 from a WX switch configuration:
WX4400# clear ntp server 192.168.40.240
success: change accepted.
See Also
clear ntp update-interval on page 142
display ntp on page 159
set ntp on page 183
set ntp server on page 184
set ntp update-interval on page 185
clear ntp
update-interval
Resets the NTP update interval to the default value.
Syntax —
clear ntp update-interval
Defaults — The default NTP update interval is 64 seconds.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — To reset the NTP interval to the default value, type the
following command:
WX4400# clear ntp update-interval
success: change accepted.
See Also
clear ntp server on page 141
display ntp on page 159
set ntp on page 183
set ntp server on page 184
set ntp update-interval on page 185