Filter
Top Products
set network-domain peer 299
See Also
clear network-domain on page 292
display network-domain on page 296
set
network-domain
peer
On a Network Domain seed, configures one or more WX as redundant
Network Domain seeds. The seeds in a Network Domain share
information about the VLANs configured on the member devices, so that
all the Network Domain seeds have the same database of VLAN
information.
Syntax —
set network-domain peer ip-addr
ip-addr — IP address of the Network Domain seed to specify as a
peer, in dotted decimal notation.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.1.
Usage — This command must be entered on a WX configured as a
Network Domain seed.
Examples — The following command sets the WX switch with IP address
192.168.9.254 as a peer of this Network Domain seed:
WX1200# set network-domain peer 192.168.9.254
success: change accepted.
See Also
clear network-domain on page 292
display network-domain on page 296