Filter
Top Products
668 CHAPTER 20: FILE MANAGEMENT COMMANDS
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — The filename and file:filename URLs are equivalent. You can
use either URL to refer to a file in an WX switch’s nonvolatile memory. The
tftp://ip-addr/filename URL refers to a file on a TFTP server. If DNS is
configured on the WX switch, you can specify a TFTP server’s hostname as
an alternative to specifying the IP address.
The tmp:filename URL specifies a file in temporary storage. You can copy
a file out of temporary storage but you cannot copy a file into temporary
storage. Temporary storage is reserved for use by MSS.
If you are copying a system image file into nonvolatile storage, the
filename must be preceded by the boot partition name, which can be
boot0 or boot1. Enter the filename as boot0:/filename or
boot1:/filename. You must specify the boot partition that was not used
to load the currently running image.
The maximum supported file size for TFTP is 32 MB.
Examples — The following command copies a file called floorwx from
nonvolatile storage to a TFTP server:
WX4400# copy floorwx tftp://10.1.1.1/floorwx
success: sent 365 bytes in 0.401 seconds [ 910 bytes/sec]
The following command copies a file called closetwx from a TFTP server to
nonvolatile storage:
WX4400# copy tftp://10.1.1.1/closetwx closetwx
success: received 637 bytes in 0.253 seconds [ 2517
bytes/sec]
The following command copies system image WXA03001.Rel from a TFTP
server to boot partition 1 in nonvolatile storage:
WX4400# copy tftp://10.1.1.107/WXA03001.Rel
boot1:WXA03001.Rel
............................................................
................................................success:
received 9163214 bytes in 105.939 seconds [ 86495 bytes/sec]