Filter
Top Products
set service-profile transmit-rates 469
The valid rates depend on the radio type:
11a—6.0, 9.0, 12.0, 18.0, 24.0, 36.0, 48.0, 54.0
11b—1.0, 2.0, 5.5, 11.0
11g—1.0, 2.0, 5.5, 6.0, 9.0, 11.0, 12.0, 18.0, 24.0, 36.0, 48.0,
54.0
Use a comma to separate multiple rates; for example: 6.0,9.0,12.0
disabled rate-list — Data transmission rates that MAP radios do
not use to transmit data. This setting applies only to data sent by the
MAP radios. The radios still accepts frames from clients at disabled
data rates.
The valid rates depend on the radio type and are the same as the valid
rates for mandatory.
beacon-rate rate — Data rate of beacon frames sent by MAP
radios. This rate is also used for probe-response frames.
The valid rates depend on the radio type and are the same as the valid
rates for mandatory. However, you cannot set the beacon rate to a
disabled rate.
multicast-rate {rate | auto} — Data rate of multicast frames
sent by MAP radios.
rate—Sets the multicast rate to a specific rate. The valid rates
depend on the radio type and are the same as the valid rates for
mandatory. However, you cannot set the multicast rate to a
disabled rate.
auto—Sets the multicast rate to the highest rate that can reach all
clients connected to the MAP radio.
Defaults — This command has the following defaults:
mandatory:
11a—6.0,12.0,24.0
11b—1.0,2.0
11g—1.0,2.0,5.5,11.0
disabled—None. All rates applicable to the radio type are supported
by default.