Filter
Top Products
294 CHAPTER 10: NETWORK DOMAIN COMMANDS
clear
network-domain
peer
Removes the configuration of a Network Domain peer from a WX
configured as a Network Domain seed.
Syntax —
clear network-domain peer {ip-addr | all}
ip-addr — IP address of the Network Domain peer in dotted decimal
notation.
all — Clears the Network Domain peer configuration for all peers
from the WX switch.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.1.
Usage — This command has no effect if the WX is not configured as a
Network Domain seed.
Examples — The following command clears the Network Domain peer
configuration for peer 192.168.9.254 from the WX:
WX1200# clear network-domain peer 192.168.9.254
success: change accepted.
The following command clears the Network Domain peer configuration
for all peers from the WX:
WX1200# clear network-domain peer all
success: change accepted.
See Also
set network-domain peer on page 299