Filter
Top Products
726 CHAPTER 24: BOOT PROMPT COMMANDS
The following command enters the configuration mode for the currently
active boot profile and configures the WX switch (in this example, an
WXR100) to boot using a TFTP server:
boot> change
Changing the default configuration is not recommended.
Are you sure that you want to proceed? (y/n)y
BOOT TYPE: [c]> n
DEVICE: [boot0:]> emac1
FILENAME: [default]> bootfile
HOST IP: [0.0.0.0]> 172.16.0.1
LOCAL IP: [0.0.0.0]> 172.16.0.21
GATEWAY IP: [0.0.0.0]> 172.16.0.20
IP MASK: [0.0.0.0]> 255.255.255.0
FLAGS: [0x00000000]>
OPTIONS: [run=nos;boot=0]>
See Also
boot on page 723
create on page 726
delete on page 727
dhcp on page 728
display on page 730
next on page 735
create Creates a new boot profile. (For information about boot profiles, see
display on page 730.)
Syntax —
create
Defaults — The new boot profile has the same settings as the currently
active boot profile by default.
Access — Boot prompt.
History —Introduced in MSS Version 3.0.