Filter
Top Products
468 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
Defaults — Static CoS is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.2.
Usage — The CoS level is specified by the set service-profile cos
command.
Examples — The following command enables static CoS on service
profile sp1:
WX4400# set service-profile sp1 static-cos enable
success: change accepted.
See Also
display service-profile on page 353
set service-profile cos on page 444
set service-profile
transmit-rates
Changes the data rates supported by MAP radios for a service-profile
SSID.
Syntax —
set service-profile name transmit-rates {11a | 11b |
11g} mandatory rate-list [disabled rate-list] [beacon-rate
rate] [multicast-rate {rate | auto}]
name — Service profile name.
11a | 11b | 11g — Radio type.
mandatory rate-list — Set of data transmission rates that clients
are required to support in order to associate with an SSID on a MAP
radio. A client must support at least one of the mandatory rates.
These rates are advertised in the basic rate set of 802.11 beacons,
probe responses, and reassociation response frames sent by MAP
radios.
Data frames and management frames sent by MAP radios use one of
the specified mandatory rates.