Filter
Top Products
17
802.1X MANAGEMENT
COMMANDS
Use 802. IEEE X management commands to modify the default settings
for IEEE 802.1X sessions on an WX. For best results, change the settings
only if you are aware of a problem with 802.1X performance on the WX.
CAUTION: 802.1X parameter settings are global for all SSIDs configured
on the switch.
Commands by
Usage
This chapter presents 802.1X commands alphabetically. Use Table 92 to
locate commands in this chapter based on their use. For information
about configuring 802.1X commands for user authentication, see “AAA
Commands” on page 211.
Table 92 802.1X Commands by Usage
Type Command
Wired Authentication Port
Control
set dot1x port-control on page 606
clear dot1x port-control on page 595
set dot1x authcontrol on page 602
Keys set dot1x key-tx on page 604
set dot1x tx-period on page 610
clear dot1x tx-period on page 599
set dot1x wep-rekey on page 611
set dot1x wep-rekey-period on page 612
Bonded Authentication clear dot1x bonded-period on page 594
set dot1x bonded-period on page 603
Reauthentication set dot1x reauth on page 607
set dot1x reauth-max on page 608
Reauthentication, cont. clear dot1x reauth-max on page 597