Filter
Top Products
set ap auto 363
The profile uses the default radio profile by default. You can change the
profile using the set ap auto radio radio-profile command. You can
use set ap auto commands to change settings for the parameters listed
in Table 71. (The commands are listed in the “See Also” section.)
Examples — The following command creates a profile for automatic
Distributed MAP configuration:
WX1200# set ap auto
success: change accepted.
See Also
set ap auto mode on page 366
set ap auto persistent on page 364
set ap auto radiotype on page 365
set ap bias on page 367
Table 71 Configurable Profile Parameters for Distributed MAPs
Parameter Default Value
MAP Parameters
bias high
blink
(Not shown in display ap config
output)
disable
force-image-download disable (NO)
group (load balancing group) none
mode disabled
persistent none
upgrade-firmware
(boot-download-enabled)
enable (YES)
Radio Parameters
radio num auto-tune
max-power
default
radio num mode enabled
radio num radio-profile default
radiotype 11g
(or 11b for country codes where
802.11g is not allowed)