Filter
Top Products
display ip route 157
Usage — When you add an IP interface to a VLAN that is up, MSS adds
direct and local routes for the interface to the route table. If the VLAN is
down, MSS does not add the routes. If you add an interface to a VLAN
but the routes for that interface do not appear in the route table, use the
display vlan config command to check the VLAN state.
If you add a static route and the route’s state is shown as Down, use the
display interface command to verify that the route has an IP interface in
the gateway router’s subnet. MSS cannot resolve a static route unless one
of the WX switch’s VLANs has an interface in the gateway router’s
subnet. If the WX switch has such an interface but the static route is still
down, use the display vlan config command to check the state of the
VLAN’s ports.
Examples — The following command shows all routes in a WX IP route
table:
WX4400# display ip route
Router table for IPv4
Destination/Mask Proto Metric NH-Type Gateway VLAN:Interface
__________________ _______ ______ _______ _______________ _______________
0.0.0.0/ 0 Static 1 Router 10.0.1.17 Down
0.0.0.0/ 0 Static 2 Router 10.0.2.17 vlan:2:ip
10.0.2.1/24 IP 0 Direct vlan:2:ip
10.0.2.1/32 IP 0 Direct vlan:2:ip:10.0.1.1/24
10.0.2.255/32 IP 0 Direct vlan:2:ip:10.0.1.1/24
224.0.0.0/ 4 IP 0 Local MULTICAST
Table 37 describes the fields in this display.
Table 37 Output of display ip route
Field Description
Destination/Mask IP address and subnet mask of the route destination.
The 244.0.0.0 route is automatically added by MSS and
supports the IGMP snooping feature.
Proto Protocol that added the route to the IP route table. The protocol
can be one of the following:
IP — MSS added the route.
Static — An administrator added the route.
Metric Cost for using the route.