Filter
Top Products
set rfdetect countermeasures mac 655
Syntax — set rfdetect countermeasures {enable | disable}
enable — Enables countermeasures.
disable — Disables countermeasures.
Defaults — Countermeasures are disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command is valid only on the seed switch of the Mobility
Domain.
Examples — The following command enables countermeasures for the
Mobility Domain managed by this seed switch:
WX1200# set rfdetect countermeasures enable
success: countermeasures are now enabled.
See Also
clear rfdetect attack-list on page 630
display rfdetect ignore on page 644
set rfdetect countermeasures mac on page 655
set rfdetect
countermeasures
mac
Starts countermeasures against a specific rogue.
Syntax —
set rfdetect countermeasures mac mac-addr
mac-addr — Basic service set identifier (BSSID) of the rogue. Enter the
BSSID in MAC address format, using a colon between each octet (for
example: aa:bb:cc:dd:ee:ff).
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — Use this command to immediately begin countermeasures
against a specific rogue in the rogue list. The MAC address you specify
must be in the list of rogues generated by RF detection scans. MSS can
issue countermeasures only against a device that is in the rogue list.