Filter
Top Products
584 CHAPTER 16: RADIUS AND SERVER GROUP COMMANDS
See Also
clear radius server on page 581
display aaa on page 229
set radius server on page 587
set radius client
system-ip
Causes all RADIUS requests to be sourced from the IP address specified by
the set system ip-address command, providing a permanent source IP
address for RADIUS packets sent from the WX switch.
Syntax —
set radius client system-ip
Defaults — None. If you do not use this command, RADIUS packets
leaving the WX have the source IP address of the outbound interface,
which can change as routing conditions change.
Examples — Enabled.
History —Introduced in MSS Version 3.0.
Usage — The WX system IP address must be set before you use this
command.
Examples — The following command sets the WX system IP address as
the address of the RADIUS client:
WX4400# set radius client system-ip
success: change accepted.
See Also
clear radius client system-ip on page 579
set system idle-timeout on page 65