Filter
Top Products
310 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
clear ap
boot-configuration
Removes the static IP address configuration for a Distributed MAP.
Syntax —
clear ap boot-configuration apnum
ap ap-number — Index value that identifies the MAP on the WX.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.2. Version 6.0 removed the dap option.
Usage — When the static IP configuration is cleared for a MAP, and a
MAP is rebooted, it uses the standard boot process.
Examples — The following command clears the static IP address
configuration for MAP 1.
WX# clear ap 1 boot-configuration
This will clear specified AP devices. Would you like to
continue? (y/n) [n]y
success: change accepted.
See Also
display ap boot-configuration on page 342
set ap boot- configuration ip on page 369
set ap boot- configuration switch on page 374
set ap boot- configuration ip on page 369
set ap boot-configuration vlan on page 375