Filter
Top Products
3
SYSTEM SERVICE COMMANDS
Use system services commands to configure and monitor system
information for a WX switch.
Commands by
Usage
This chapter presents system service commands alphabetically. Use
Table 6 to locate commands in this chapter based on their use.
Table 6 System Services Commands by Usage
Type Command
Configuration quickstart on page 52
Auto-Config set auto-config on page 52
Display clear banner motd on page 42
quickstart on page 52
display banner motd on page 45
set banner acknowledge on page 54
set confirm on page 57
set length on page 57
System Identification set prompt on page 59
set system name on page 68
set system location on page 67
set system contact on page 60
set system countrycode on page 61
set system idle-timeout on page 65
set system idle-timeout on page 65
display load on page 47
display system on page 47