Filter
Top Products
182 CHAPTER 7: IP SERVICES COMMANDS
Defaults — The default Telnet port number is 23.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command changes the Telnet port number
on a WX to 5000:
WX4400# set ip telnet 5000
success: change accepted.
See Also
clear ip telnet on page 141
display ip https on page 155
display ip telnet on page 158
set ip https server on page 177
set ip telnet server on page 182
set ip telnet server Enables the Telnet server on a WX.
CAUTION: If you disable the Telnet server, Telnet access to the WX is also
disabled.
Syntax —
set ip telnet server {enable | disable}
enable — Enables the Telnet server.
disable — Disables the Telnet server.
Defaults — The Telnet server is disabled by default.
Access — Enabled.
Usage — The maximum number of Telnet sessions supported on a WX is
eight. If SSH is also enabled, the WX can have up to eight Telnet or SSH
sessions, in any combination, and one console session.
Examples — The following command enables the Telnet server on a WX:
WX4400# set ip telnet server enable
success: change accepted.