Filter
Top Products
206 CHAPTER 7: IP SERVICES COMMANDS
Examples — To set the time zone for Pacific Standard Time (PST), type
the following command:
WX1200# set timezone PST -8
Timezone is set to 'PST', offset from UTC is -8:0 hours.
See Also
clear summertime on page 145
clear timezone on page 146
display summertime on page 164
display timedate on page 165
display timezone on page 165
set summertime on page 202
set timedate on page 204
telnet Opens a Telnet client session with a remote device.
Syntax — telnet {ip-addr | hostname} [port port-num]
ip-addr — IP address of the remote device.
hostname — Hostname of the remote device.
port port-num — TCP port number on which the TCP server on the
remote device listens for Telnet connections.
Defaults — MSS attempts to establish Telnet connections with TCP port
23 by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — To end a Telnet session from the remote device, press Ctrl+t or
type quit or logout in the management session on the remote device. To
end a client session from the local WX switch, use the clear sessions
telnet client command.
If the configuration of the WX switch from which you enter the telnet
command has an ACL that denies Telnet client traffic, the ACL also denies
access by the telnet command.