Filter
Top Products
38 CHAPTER 2: ACCESS COMMANDS
enable Places the CLI session in enabled mode, which provides access to all
commands required for configuring and monitoring the system.
Syntax —
enable
Access — All.
History — Introduced in MSS Version 3.0.
Usage — MSS displays a password prompt to challenge you with the
enable password. To enable a session, your or another administrator must
have configured the enable password to this WX switch with the set
enablepass command.
Examples — The following command plus the enable password provides
enabled access to the CLI for the current sessions:
WX1200> enable
Enter password: password
WX1200#
See Also
set enablepass on page 39
set confirm on page 57
quit Exit from the CLI session.
Syntax — quit
Defaults — None.
Access — All.
History — Introduced in MSS Version 3.0.
Examples — To end the administrator’s session, type the following
command:
WX1200> quit