Filter
Top Products
set ntp 183
See Also
clear ip telnet on page 141
display ip https on page 155
display ip telnet on page 158
set ip https server on page 177
set ip telnet on page 181
set ntp Enables or disables the NTP client on a WX.
Syntax — set ntp {enable | disable}
enable — Enables the NTP client.
disable — Disables the NTP client.
Defaults — The NTP client is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If NTP is configured on a system whose current time differs
from the NTP server time by more than 10 minutes, convergence of the
WX time can take many NTP update intervals. 3Com recommends that
you set the time manually to the NTP server time before enabling NTP to
avoid a significant delay in convergence.
Examples — The following command enables the NTP client:
WX4400# set ntp enable
success: NTP Client enabled
See Also
clear ntp server on page 141
clear ntp update-interval on page 142
display ntp on page 159
set ntp server on page 184
set ntp update-interval on page 185