Filter
Top Products
582 CHAPTER 16: RADIUS AND SERVER GROUP COMMANDS
Examples — To remove the server group sg-77 type the following
command:
WX4400# clear server group sg-77
success: change accepted.
To disable load balancing in a server group shorebirds, type the following
command:
WX4400# set server group shorebirds load-balance disable
success: change accepted.
See Also
set server group on page 589
set radius Configures global defaults for RADIUS servers that do not explicitly set
these values themselves. By default, the WX switch automatically sets all
these values except the password (key).
Syntax —
set radius {deadtime minutes | encrypted-key string
| key string | retransmit number | timeout seconds}
deadtime minutes — Number of minutes the WX switch waits after
declaring an unresponsive RADIUS server unavailable before retrying
the RADIUS server. You can specify from 0 to 1440 minutes.
encrypted keyword string — Password (shared secret key) used to
authenticate to the RADIUS server, entered in its encrypted form. You
must provide the same encrypted password that is defined on the
RADIUS server. The password can be 1 to 64 characters long, with no
spaces or tabs.
MSS does not encrypt the string you enter, and instead displays the
string in display config and display aaa output exactly as you
entered it.
Note: Use this option only if you are entering the key in its encrypted
form. To enter the key in unencrypted form, use the key string option
instead.
key string — Password (shared secret key) used to authenticate to
the RADIUS server. You must provide the same password that is
defined on the RADIUS server. The password can be 1 to 64 characters
long, with no spaces or tabs.