Filter
Top Products
526 CHAPTER 13: IGMP SNOOPING COMMANDS
set igmp lmqi Changes the IGMP last member query interval timer on one VLAN or all
VLANs on a wireless LAN switch.
Syntax —
set igmp lmqi tenth-seconds [vlan vlan-id]
lmqi tenth-seconds — Amount of time (in tenths of a second) that
the WX waits for a response to a group-specific query after receiving a
leave message for that group, before removing the receiver that sent
the leave message from the list of receivers for the group. If there are
no more receivers for the group, the WX switch also sends a leave
message for the group to multicast routers. You can specify a value
from 1 through 65,535.
vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, the timer change applies to all VLANs.
Defaults — The default last member query interval is 10 tenths of a
second (1 second).
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command changes the last member query
interval on VLAN orange to 5 tenths of a second:
WX1200# set igmp lmqi 5 vlan orange
success: change accepted.
See Also
set igmp oqi on page 529
set igmp qi on page 531
set igmp mrouter on page 527