Filter
Top Products
22
SNOOP COMMANDS
Use snoop commands to monitor wireless traffic, by using a MAP as a
sniffing device. The MAP copies the sniffed 802.11 packets and sends the
copies to an observer, which is typically a protocol analyzer such as
Ethereal or Tethereal.
(For more information, including setup instructions for the monitoring
station, see the “Remotely Monitoring Traffic” section in the
“Troubleshooting a WX Switch” chapter of the Wireless LAN Switch and
Controller Configuration Guide.)
Commands by
Usage
This chapter presents snoop commands alphabetically. Use the following
table to locate commands in this chapter based on their use.
Table 117 Remote Monitoring (Snooping) Commands By Usage
Remote
monitoring
(snooping)
set snoop on page 701
display snoop info on page 706
display snoop stats on page 708
clear snoop on page 700
set snoop map on page 704
display snoop map on page 707
display snoop on page 706
clear snoop map on page 700
set snoop mode on page 705
display snoop stats on page 708