Filter
Top Products
440 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
set service-profile
cipher-ccmp
Enables Counter with Cipher Block Chaining Message Authentication
Code Protocol (CCMP) encryption with WPA clients, for a service profile.
Syntax —
set service-profile name cipher-ccmp
{enable | disable}
name — Service profile name.
enable — Enables CCMP encryption for WPA clients.
disable — Disables CCMP encryption for WPA clients.
Defaults — CCMP encryption is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — To use CCMP, you must also enable the WPA IE.
Examples — The following command configures service profile sp2 to
use CCMP encryption:
WX4400# set service-profile sp2 cipher-ccmp enable
success: change accepted.
See Also
display service-profile on page 353
set service-profile cipher-tkip on page 441
set service-profile cipher-wep104 on page 442
set service-profile cipher-wep40 on page 443
set service-profile wpa-ie on page 481