Filter
Top Products
set log 717
Logging state (enabled or disabled)
To override the session defaults for an individual session, type the set
log command from within the session and use the current option.
trace — Sets log parameters for trace files.
Port port-number — Sets the TCP port for sending messages to the
syslog server. You can specify a number from 1 to 65535. The default
syslog port is 514.
severity severity-level — Logs events at a severity level greater
than or equal to the level specified. Specify one of the following:
emergency — The WX switch is unusable.
alert — Action must be taken immediately.
critical — You must resolve the critical conditions. If the
conditions are not resolved, the WX can reboot or shut down.
error — The WX is missing data or is unable to form a connection.
warning — A possible problem exists.
notice — Events that potentially can cause system problems have
occurred. These are logged for diagnostic purposes. No action is
required.
info — Informational messages only. No problem exists.
debug — Output from debugging.
local-facility facility-level — For messages sent to a syslog
server, maps all messages of the severity you specify to one of the
standard local log facilities defined in RFC 3164. You can specify one
of the following values:
0 — maps all messages to local0.
1 — maps all messages to local1.
2 — maps all messages to local2.
3 — maps all messages to local3.
4 — maps all messages to local4.
5 — maps all messages to local5.
6 — maps all messages to local6.
7 — maps all messages to local7.