Filter
Top Products
518 CHAPTER 13: IGMP SNOOPING COMMANDS
See Also
display igmp mrouter on page 518
display igmp querier on page 519
display igmp receiver-table on page 521
display igmp statistics on page 523
display igmp
mrouter
Displays the multicast routers in a WX’s subnet, on one VLAN or all
VLANs. Routers are listed separately for each VLAN, according to the port
number through which the wireless LAN switch can reach the router.
Syntax —
display igmp mrouter [vlan vlan-id]
vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, MSS displays the multicast routers in all VLANs.
Defaults — None.
Access — All.
History — Introduced in MSS Version 3.0.
Examples — The following command displays the multicast routers in
VLAN orange:
WX1200# display igmp mrouter vlan orange
Multicast routers for vlan orange
Port Mrouter-IPaddr Mrouter-MAC Type TTL
---- --------------- ----------------- ----- -----
1 192.28.7.5 00:01:02:03:04:05 dvmrp 33
Table 82 describes the fields in this display.
VLAN VLAN name. MSS displays information separately for each
VLAN.
IGMP is enabled
(disabled)
IGMP state.
Table 81 Output for display igmp (continued)
Field Description