Filter
Top Products
370 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
See Also
clear ap boot-configuration on page 310
display ap boot-configuration on page 342
set ap boot-configuration vlan on page 375
set ap boot-
configuration mesh
mode
Enables WLAN mesh services on the MAP.
Syntax —
set ap ap-number boot-configration mesh mode [mode
{
enable | disable}]
ap ap-number — Index value that identifies the MAP on the WX.
mode {enable | disable} — Enables or disables WLAN mesh services
for the MAP.
Defaults — Disabled.
Access — Enabled.
History —Introduced in MSS version 6.0.
Usage — Use this command to enable WLAN mesh services for an Mesh
AP. Prior to deploying the Mesh AP in its final untethered location, you
must connect the MAP to an WX and enter this command to configure
the MAP for mesh services.
Examples — The following command enables WLAN mesh services for
MAP 7:
WX4400# set ap 7 boot-configuration mesh mode enable
success: change accepted.
See Also
display ap mesh-links on page 329
set ap boot-configuration mesh ssid on page 373
set service-profile mesh on page 450