Filter
Top Products
set snmp usm 201
Defaults — No SNMPv3 users are configured by default. When you
configure an SNMPv3 user, the default access is read-only, and the
default authentication and encryption types are both none.
Access — Enabled.
History — Introduced in MSS Version 4.0.
Examples — The following command creates USM user snmpmgr1,
associated with the local SNMP engine ID. This user can send traps to
notification receivers.
WX#1200 set snmp usm snmpmgr1 snmp-engine-id local
success: change accepted.
The following command creates USM user securesnmpmgr1, which uses
SHA authentication and 3DES encryption with passphrases. This user can
send informs to the notification receiver that has engine ID 192.168.40.2.
WX4400# set snmp usm securesnmpmgr1 snmp-engine-id ip
192.168.40.2 auth-type sha auth-pass-phrase myauthpword
encrypt-type 3des encrypt-pass-phrase mycryptpword
success: change accepted.
See Also
clear snmp usm on page 144
set ip snmp server on page 180
set snmp community on page 185
set snmp notify target on page 192
set snmp notify profile on page 187
set snmp protocol on page 197
set snmp security on page 198
display snmp usm on page 164