Filter
Top Products
492 CHAPTER 12: STP COMMANDS
Examples — The following example shows the command output on a
WX switch with backbone fast convergence enabled:
WX4400# display spantree backbonefast
Backbonefast is enabled
See Also
set spantree backbonefast on page 502
display spantree
blockedports
Lists information about wireless LAN switch ports that STP has blocked on
one or all of its VLANs.
Syntax —
display spantree blockedports [vlan vlan-id]
vlan vlan-id — VLAN name or number. If you do not specify a VLAN,
MSS displays information for blocked ports on all VLANs.
Defaults — None.
Access — All.
History —Introduced in MSS Version 3.0.
Usage — The command lists information separately for each VLAN.
Examples — The following command shows information about blocked
ports on a WX switch for the default VLAN (VLAN 1):
WX4400# display spantree blockedports vlan default
Port Vlan Port-State Cost Prio Portfast
------------------------------------------------------------------------
2 190 Blocking 4 128 Disabled
Number of blocked ports (segments) in VLAN 1 : 1
The port information is the same as the information displayed by the
display spantree command. See Table 75 on page 489.
See Also
display spantree on page 488