Filter
Top Products
display port counters 75
Examples — The following command clears port 5:
WX1200# clear port type 5
This may disrupt currently authenticated users.
Are you sure? (y/n) [n]y
success: change accepted.
See Also
set port type ap on page 97
set port type wired-auth on page 100
display port
counters
Displays port statistics.
Syntax — display port counters
[octets | packets | receive-errors | transmit-errors |
collisions | receive-etherstats |
transmit-etherstats] [port port-list]
octets — Shows octet statistics.
packets — Shows packet statistics.
receive-errors— Shows errors in received packets.
transmit-errors — Shows errors in transmitted packets.
collisions — Shows collision statistics.
Table 10 Network port defaults
Port Parameter Setting
VLAN membership None.
Note: Although the command changes a port to a
network port, the command does not place the port
in any VLAN. To use the port in a VLAN, you must
add the port to the VLAN.
Spanning Tree Protocol (STP) Based on the VLAN(s) you add the port to.
802.1X No authorization.
Port groups None.
Internet Group Management
Protocol (IGMP) snooping
Enabled as port is added to VLANs.
Access point and radio
parameters
Not applicable
Maximum user sessions Not applicable