Filter
Top Products
442 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
set service-profile
cipher-wep104
Enables dynamic Wired Equivalent Privacy (WEP) with 104-bit keys, in a
service profile.
Syntax —
set service-profile name cipher-wep104 {enable |
disable}
name — Service profile name.
enable — Enables 104-bit WEP encryption for WPA clients.
disable — Disables 104-bit WEP encryption for WPA clients.
Defaults — 104-bit WEP encryption is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — To use 104-bit WEP with WPA clients, you must also enable the
WPA IE.
When 104-bit WEP in WPA is enabled in the service profile, radios
managed by a radio profile that is mapped to the service profile can also
support non-WPA clients that use dynamic WEP.
To support WPA clients that use 40-bit dynamic WEP, you must enable
WEP with 40-bit keys. Use the set service-profile cipher-wep40
command.
Microsoft Windows XP does not support WEP with WPA. To configure a
service profile to provide dynamic WEP for XP clients, leave WPA disabled
and use the set service-profile wep commands.
To support non-WPA clients that use static WEP, you must configure static
WEP keys. Use the set service-profile wep key-index command.
Examples — The following command configures service profile sp2 to
use 104-bit WEP encryption:
WX4400# set service-profile sp2 cipher-wep104 enable
success: change accepted.