Filter
Top Products
728 CHAPTER 24: BOOT PROMPT COMMANDS
Usage — When you type the delete command, the next-lower
numbered boot profile becomes the active profile. For example, if the
currently active profile is number 3, profile number 2 becomes active after
you type delete to delete profile 3. You cannot delete boot profile 0.
Examples — To remove the currently active boot profile, type the
following command:
boot> delete
BOOT Index: 1
BOOT TYPE: c
DEVICE: boot1:
FILENAME: default
FLAGS: 00000000
OPTIONS: run=nos;boot=0
See Also
change on page 725
create on page 726
display on page 730
next on page 735
dhcp Displays or changes the state of the DHCP option. The DHCP option
controls whether a WX switch uses DCHP to obtain its IP address when it
is booted using a TFTP server.
Syntax —
dhcp [ON | on | OFF | off]
ON — Enables the DHCP option.
on — Same effect as ON.
OFF — Disables the DHCP option.
off — Same effect as OFF.
Defaults — The DHCP option is disabled by default.
Access — Boot prompt.
History —Introduced in MSS Version 1.0.