Filter
Top Products
11
MANAGED ACCESS POINT
COMMANDS
Use MAP access point commands to configure and manage MAP access
points. Be sure to do the following before using the commands:
Define the country-specific IEEE 802.11 regulations on the WX switch.
(See set system countrycode on page 61.)
Install the MAP access point and connect it to a port on the WX
switch.
Configure a MAP as a directly connected MAP or a Distributed MAP.
(See set port type ap on page 97 and set ap on page 87.)
CAUTION: Changing the system country code after MAP configuration
disables MAP access points and deletes their configuration. If you change
the country code on a WX, you must reconfigure all MAP access points.
MAP Access Point
Commands by
Usage
This chapter presents MAP access point commands alphabetically. Use the
following table to locate commands in this chapter based on their use.
Table 50 Map Access Point Commands by Usage
Type Command
Automatic
Configuration of
Distributed MAPs
set ap auto on page 362
set ap auto mode on page 366
set ap auto radiotype on page 365
set ap auto persistent on page 364
set ap bias on page 367
set ap blink on page 368
set ap group on page 379
set ap radio auto-tune max-power on page 384