Filter
Top Products
420 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
set radio-profile
qos-mode
Sets the prioritization mode for forwarding queues on MAP radios
managed by the radio profile.
Syntax — set radio-profile name qos-mode {svp | wmm}
svp — Optimizes forwarding prioritization of MAP radios for
SpectraLink Voice Priority (SVP).
wmm — Classifies and marks traffic based on 802.1p and DSCP, and
optimizes forwarding prioritization of MAP radios for Wi-Fi
Multimedia (WMM).
Defaults — The default QoS mode is wmm.
Access — Enabled.
History —Introduced in MSS Version 4.2.
Usage — When SVP is enabled, MAP forwarding prioritization is
optimized for SpectraLink Voice Priority (SVP) instead of WMM, and the
MAP does not tag packets sent to the WX. Otherwise, classification and
tagging remain in effect. (For information, see the “Configuring Quality
of Service” chapter of the Wireless LAN Switch and Controller
Configuration Guide.)
If you plan to use SVP or another non-WMM type of prioritization, you
must configure ACLs to tag the packets. (See the “Enabling Prioritization
for Legacy Voice over IP” section in the “Configuring and Managing
Security ACLs” chapter of the Wireless LAN Switch and Controller
Configuration Guide.)
Examples — The following command changes the QoS mode for radio
profile rp1 to SVP:
WX4400# set radio-profile rp1 qos-mode svp
success: change accepted.
See Also
display radio-profile on page 350
set radio-profile mode on page 416