Filter
Top Products
clear network-domain seed-ip 295
clear
network-domain
seed-ip
Removes the specified Network Domain seed from the WX configuration.
When you enter this command, the Network Domain TCP connections
between the WX switch and the specified Network Domain seed are
closed.
Syntax —
clear network-domain seed-ip ip-addr
ip-addr — IP address of the Network Domain seed in dotted decimal notation.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.1.
Usage — This command has no effect if the WX is not configured as part of
a Network Domain, or if the WX is not configured as a member of a Network
Domain that uses the specified Network Domain seed.
The following command removes the Network Domain seed with IP
address 192.168.9.254 from the WX configuration:
WX1200# clear network-domain seed-ip 192.168.9.254
success: change accepted.
See Also
set network-domain mode member seed-ip on page 298