Filter
Top Products
366 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
set ap auto mode Enables a WX profile for automatic Distributed MAP configuration.
Syntax —
set ap auto mode {enable | disable}
enable — Enables the MAP configuration profile.
disable — Disables the MAP configuration profile.
Defaults — The MAP configuration profile is disabled by default.
Access — Enabled.
History —Introduced in MSS 4.0. Version 6.0 removed the dap option.
Usage — You must use the set ap auto command to create the profile
before you can enable it.
Examples — The following command enables the profile for automatic
Distributed MAP configuration:
WX4400# set ap auto mode enable
success: change accepted.
See Also
set ap auto on page 362
set ap auto persistent on page 364
set ap auto radiotype on page 365
set ap bias on page 367
set ap blink on page 368
set ap group on page 379
set ap radio auto-tune max-power on page 384
set ap radio auto-tune max- retransmissions on page 385
set ap radio link-calibration on page 388
set ap radio mode on page 391
set ap radio radio-profile on page 392
set ap upgrade-firmware on page 396