Filter
Top Products
D9412GV2/D7412GV2 | Program Entry Guide | 2.0 GV2MAIN EN | 70
Bosch Security Systems, Inc. | 10/08 | F01U003636-04
L## Send Report
L## Cycle Door
Default: Refer to the program record sheet
Default: Refer to the program record sheet
Selection: Blank or E
Selection: Blank or E
Function Name
Function
No.
Alternate
Keystroke
Function Name
Function
No.
Alternate
Keystroke
(None) Cycle Door
(Menu function
only)
13 Send Report
[COMMAND][4][1]
or
[COMMAND][4][2]
Cycle Door (Menu Function only)
Send a Test Report from any keypad assigned to an
area where the user has authority.
To cycle the doors, press number [1] through [8] on
the keypad, corresponding to the door number. For
example, pressing [2] and [ENTER] cycles door
number 2, which is indicated by C in the display.
Refer to “Cycle Door” in
Access Control Functions
Use the following functions to control the doors from
the keypad. Users can have authority to access the
Door Control and can use all or part of the functions
within.
Table 29 on page 71.
Cycle Door allows the user with this authority level to
access the CYCLE? 12345678 function.
L## Unlock Door
All doors display when this function is
selected. This function does not follow
Default: Refer to the program record sheet
the scope of the keypad.
Selection: Blank or E
L## Door Control
Function Name
Function
No.
Alternate
Keystroke
Default: Refer to the program record sheet
(None) Unlock Door
(Menu function
only)
Selection: Blank or E
Function
No.
Function Name
Alternate
Keystroke
14 Door Control [COMMAND][4][6]
To unlock or relock a door, press number [1] through
[8] on the keypad, correspoding to the door number
(refer to “Unlock Door” in
Table 29 on page 71). For
example, pressing [2] and [ENTER] unlocks door
number 2. The display indicates “U’ (for unlock door)
with the door number. Select the same door number
again and press [Enter] to relock the door.
This item only allows programming access to the
following three sub-prompts. It does not affect the
user’s access to Cycle Door, Unlock Door, and
Secure Door.
Unlock Door allows the user with this authority level to
access the UNLOCK? 12345678 function.
Cycle Door, Unlock Door, and Secure
Door cannot be accessed through the
L## Secure Door
Function List. Door Control must be
added to the Function List to access the
door control functions, or COMMAND 46
can be used.
Default: Refer to the program record sheet
Selection: Blank or E
Function Name
Function
No.
Alternate
Keystroke
The following prompts are sub-functions of Door
Control. They become visible in the D5200
Programmer when you Enable Door Control and
press [ENTER] on the D5200.
(None) Secure Door
(Menu function
only)
Press number [1] through [8] on the keypad,
corresponding to the door number to secure or
unsecure a door (refer to “Secure Door” in
Cycle Door must be enabled for all three
sub-functions to operate. If Cycle Door is
Table 29
on page
disabled, all three sub-functions do not
71).For example, pressing [2] and [ENTER]
secures door number 2, which is indicated by an X in
the display.
operate.
Secure Door allows the user with this authority level
to access the SECURE? 12345678 function.