Filter
Top Products
D9412GV2/D7412GV2 | Program Entry Guide | 2.0 GV2MAIN EN | 26
Bosch Security Systems, Inc. | 10/08 | F01U003636-04
A user might not want all four fields to show in the
pager message. Entering “*” characters in the phone
number allows the user to select the number of fields
to show in the pager message. To limit the number of
fields shown in the pager message, enter the
appropriate number of “*” characters in the phone
number as shown below:
Figure 1: Pager Display Fields
[1234-001-011-008]
1 2
3
4
1 - Account number (1234)
2 - Event policy (001)
3 - Event number (011, Fire Alarm Event)
4 - User number, point number, or relay number
(008)
The account number must contain four
numeric digits. No alpha characters (B to
F) are allowed when using the numeric
pager.
Programming the Pager Phone Number
To program the pager phone number, enter the
number used to reach the pager, followed by pauses.
Entering C creates a 3-sec pause (example:
5552341CCC.)
Experiment with the number of pauses you add after
the page phone number. Each pause equals 3 sec.
Try calling the pager yourself first and listening to the
length of time it takes to get a beep allowing you to
enter touch-tone information. This length is what you
must program after the pager’s phone number in
Section
2.1 Phone on page 11 If you need a longer
pause, enter D after the number. Each D equals
7 sec.
Using “#” characters in the phone number affects the
event’s display on the pager:
•
•
•
•
•
•
•
•
Zero “*” characters in phone number: Shows
all four fields.
One “*” character in phone number: Shows
first field only.
Two “*” characters in phone number: Shows
first two fields.
Three “*” characters in phone number: Shows
first three fields.
Four or more “*” characters in phone number:
Shows all four fields.
For example, the phone number 2773074***CC
(seven digit pager phone number followed by three
asterisks and two pauses) produces the following
pager display: [1234-001-011] (three fields display at
the pager).
Table 21 shows the description of each event, its
priority, and event number.
No “#” characters in phone number: Dashes
appear in the display [1234-001-011-008].
One “#” character in phone number: Dashes
are replaced by zeros [1234000100110008].
Two or more “#” characters in phone number:
Dashes appear in the display [1234-001-011-
008].
For example, if the phone number 2773074#CC
(seven-digit pager phone number followed by “#” and
two pauses) is programmed, the pager message
appears as follows: [1234000100110008] (dashes
are replaced by zeros).
If the “#” is not placed in the phone number, the
message appears as follows: [1234-001-011-008]