Filter
Top Products
D9412GV2/D7412GV2 | Program Entry Guide | 2.0 GV2MAIN EN | 21
Bosch Security Systems, Inc. | 10/08 | F01U003636-04
Table 14: Diagnostic Reports (Continued)
Report Selections
Report
Description
R# Checksum Fail Yes, No
Checksum Fail
Event
R# Network Fail
4
Yes, No
Failure of
network
R# Network Rest
4
Yes, No
Restoral of
network
R# Network Cond
4
Yes, No
Condition of
network
1 This event is included in the Expanded Test Report
when an off-normal condition exists..
2 To meet UL 864 requirements for Central Station and
Remote Station applications, enable AC Fail, Battery
Missing, Low Battery, Battery Restoral, and AC
Restoral reports.
3 This event covers Comm Fail Route Group and Comm
Fail Phone. If enabled, both events are sent; if disabled,
neither event is sent
4
This event is reserved for future use.
Enable Rt Comm Fail and Rt Comm
Restore in only one route group.
Relay Reports
Selecting Yes enables sending a report when the
event occurs.
Table 15: Relay Reports
Report Selections
Report
Description
R# Sensor
Reset
Yes, No
Sensor Reset
Event
R# Relay Set Yes, No Relay Set Event
R# Relay
Reset
Yes, No Relay Reset Event
When activating an on-board relay using
remote automation software, the
D9412GV2 and D7412GV2 Control
Panels log and print the resulting event
as:
Relay 250 (Relay A)
Relay 251 (Relay B)
Relay 252 (Relay C)
AutoFunc Reports
The following prompts support customized routing of
Auto Function Reports. Selecting Yes enables a
report to be sent when the event occurs.
Table 16: Auto-Function Reports
Report Selections Report Description
Yes, No
R# Sked Sked Executed
Executed Event
Yes, No
R# Sked
Changed
Sked Changed
Event
Yes, No
R# Execute Fail to Execute
Fail Event
RPS Reports
Selecting Yes enables sending a report when the
RPS Passcode Event occurs.
RPS Access Fail can indicate a wrong
RPS passcode when communicating
with the control panel or a valid RPS
session terminated by a means other
than a Good-bye or Reset-bye
command. Remote Reset indicates a
Reset-bye command issued from RPS;
Bad Call to RPS indicates the control
panel called RPS but was unable to
connect.