Filter
Top Products
D9412GV2/D7412GV2 | Program Entry Guide | 6.0 GV2AUX EN | 140
Bosch Security Systems, Inc. | 10/08 | F01U003636-04
Fire Supv Res Type
Early Ambush Timer
Default: 0
Default: 10 min
Selection: 0, 1, 2
Selection: 5 to 30 min
The control panel sends a FIRE
TROUBLE RESTORE when a Fire
Supervision point restores to normal.
0
The programmed time is the maximum value of the
Early Ambush Timer. When Early Ambush is set to
Yes for a specified area (refer to
A# Early Ambush on
page
The control panel sends a FIRE
ALARM RESTORE when a Fire
Supervision point restores to normal.
1 48) and the area is disarmed, the user has the
amount of time programmed here to enter a second
code into the keypad.
2
The control panel sends a FIRE
SUPERVISION RESTORE when a
Fire Supervision point restores to
normal.
If a second pass code is not entered within the
programmed time, a Duress event is generated based
on the first user code. Duress reports must be
enabled in Routing in order to be sent to a central
station.
Determines how the control panel sends a Fire
Supervision Restoral Event.
Secondary Ambush Code
The Fire Supv Restore Event is part of
Fire Events in Routing. If Fire Supervision
Default: Unique
Restore Events are needed, simply
Selection: Unique or any
enable them in Routing.
The code used to end the timer must
be different from the code used to
disarm the area.
Unique
Enable Protocol Type
Default: No
The timer can be stopped using a
different code, or the same code that
disarmed the area.
Any
Selection: Yes or No
Not required. Leave at default value.
The Secondary Ambush Code determines whether
the same pass code can be used to begin and end
the Early Ambush process.
Fire Trouble Resound
Default: 0
Abort Window
Selection: 0, 1, 2
Default: 30 sec
Keypads do not re-sound the fire
trouble tone.
0
Selection:
15 to 45 sec
Keypads re-sound the fire trouble
tone at 12:00 PM if any Fire point
that falls within the scope of a
keypad is in an off-normal condition.
1
This parameter determines the amount of time the
control panel delays a Burglar Alarm event from a
point with P## Alarm Abort set to Yes. If an alarm
silence operation is performed before this time
elapses, the alarm transmission is aborted and the
keypad shows an optional ALARM NOT SENT
message. When an alarm transmission is successfully
aborted, no event is written to the control panel event
log.
Keypads re-sound the fire trouble
tone at 12:00 AM if any Fire point
that falls within the scope of a
keypad is in an off-normal condition.
2
This item determines if a fire trouble condition,
previously acknowledged and silenced at a keypad,
automatically (locally) re-sounds the fire trouble tone
at 12:00 PM, 12:00 AM, or not at all if the point is still
in an off-normal state. Events are not generated at the
time the re-sound occurs.
When an abort alarm timer starts, it does not stop
until an alarm silence operation is performed or the
time expires.
This feature does not apply to Fire Alarms
or invisible point alarms.
For SIA CP-01 Compliance:
Abort Window is a required parameter.