Filter
Top Products
D9412GV2/D7412GV2 | Program Entry Guide | 6.0 GV2AUX EN | 129
Bosch Security Systems, Inc. | 10/08 | F01U003636-04
Using this function allows the control panel, after
verifying the RPS pass code, to provide an additional
level of security. Before allowing any upload or
download, it ends the SDI RPS session and then
reconnects with RPS using one of the following:
Call Back Enabled
Default: No
Selection: Yes or No
When the control panel hears the
correct RPS password (refer to RPS
Passcode in Section
Yes
2.7 RPS
Parameters
on page 32), it ends the
SDI RPS session and then
reconnects to RPS using the RPS IP
Address if Enable Ext Modem is set
to No.
If Enable Ext Modem is set to Yes,
the control panel re-establishes
communication with RPS using the
RPS Dial String. This ensures that
the control panel communicates only
with valid RPS units.
•
•
The RPS IP Address (Enable Ext Modem must
be set to No)
The RPS Dial String (Enable Ext Modem must
be set to Yes)
No
The SDI RPS session starts
immediately; no call-back is
required. The control panel can
engage in SDI RPS sessions
regardless of the originating location.
Do not enable RPS Call Back when using
an external modem.
Figure 6: COMMAND 43 Flow Chart
1
2
9
10
11
3
9
10
6
11
11
4
7
5
8
1 - COMMAND 43 7 - Begins RPS session over the network
2 - Contact RPS? 8 - Seizes phone line and begins RPS session
3 - RPS via Phone? 9 - [PREV]
4 - Seizes phone line and calls RPS 10 - [NEXT]
5 - Answer now? 11 - [ENT]
6 - RPS by network?