Filter
Top Products
D9412GV2/D7412GV2 | Program Entry Guide | 2.0 GV2MAIN EN | 39
Bosch Security Systems, Inc. | 10/08 | F01U003636-04
When power restores to the points, the 60-sec
confirmation window starts. If any detector, reset
during the verification time, experiences another
alarm during the confirmation window, an alarm
occurs. If there is no activity during this period, no
alarm occurs and the verification window ends. If a
Verification point senses another alarm after the
window ends, a new verification cycle begins. Refer
to
When an Alarm Verification point senses an alarm,
the control panel automatically removes power to all
Resettable points connected to the area’s Reset
Sensors relay. The sensor reset removes power to
the sensors for the amount of time programmed in
Verify Time. When power is reapplied, a 60-sec
confirmation window begins. If the detector is still in
alarm and experiences another alarm during the
confirmation window, or a different Resettable
Verification point in the area senses an alarm, an
alarm occurs.
Table 24 for an example of Verify Time.
To meet UL 864 requirements, set A#
Verify Time to 60 sec.
Example: Verify Time is set for 20 sec. The alarm
verification cycle starts when the detector senses
smoke or fire. No report occurs.
When the detector senses smoke or fire, the area’s
sensor reset relay interrupts power to points
connected to it for the time in Verify Time.
Table 24: Verify Time
Restart Alarm
Verification Cycle if
an Alarm
Verification point
activates.
Verification Point
Activiation
Verify Time/Reset
Sensors
60 sec
Confirmation
Power removed,
ignore activity
Generate alarm if
additional activity
received.
*
20 Sec 60 Sec
Example: Total
Cycle time 80 sec
A# Duress Enable
Default: No
Selection:
Yes or No
Yes Enable Duress alarm for this area.
No Disable Duress alarm for this area.
Refer to Duress Type in Section 2.8 Miscellaneous
on page
35 for an explanation of duress.
The passcode you normally use for
duress is not valid in an area with A#
Duress Enable set to No.
If a passcode with the appropriate
L# Disarm authority is used to duress
disarm an area with A# Duress Enable
set to No, NO AUTHORITY appears in
the display. Also, if the keypad display
is moved to an area with A# Duress
Enable set to No using
[COMMAND][5][0], a valid duress
disarm passcode does not send a
duress report.
For SIA CP-01 Compliance:
A# Duress Enable must be set to Yes.