Filter
Top Products
D9412GV2/D7412GV2 | Program Entry Guide | 6.0 GV2AUX EN | 133
Bosch Security Systems, Inc. | 10/08 | F01U003636-04
To use an off-the-shelf external modem and a D9133DC serial module to connect to the control
panel using RPS, use the following settings:
1. GV2AUX\ENHANCED COMM\Enhanced Comm\No
2. GV2AUX\SDI RPS PARAMETERS\Enable SDI RPS\Yes
3. GV2AUX\SDI RPS PARAMETERS\Callback Enabled\No
4. GV2AUX\SDI RPS PARAMETERS\RPS IP Address 1-4\0
5. GV2AUX\SDI RPS PARAMETERS\Enable Ext Modem\Yes
6. GV2AUX\SDI RPS PARAMETERS\Answer Armed\1 to 15
7. GV2AUX\SDI RPS PARAMETERS\Answer Disarmed\1 to 15
8. GV2AUX\SDI RPS PARAMETERS\RPS Line Monitor\No
9. GV2AUX\SDI RPS PARAMETERS\Seize Relay\No
10. GV2AUX\SDI RPS PARAMETERS\Modem Init String\ATE0
11. GV2AUX\SDI RPS PARAMETERS\RPS Dial String\ (blank)
12. GV2AUX\SDIRPS/ENHANCED CONF\Baud Rate\9600
13. GV2AUX\SDIRPS/ENHANCED CONF\Parity/Stop No\1
14. GV2AUX\SDIRPS/ENHANCED CONF\RTS Control\ON
15. GV2AUX\SDIRPS/ENHANCED CONF\DTR Control\ON
16. GV2AUX\SDIRPS/ENHANCED CONF\9133 Supervision\No
17. GV2MAIN\PANEL WIDE PARAMETER\Enhanced Routing\RG1 Primary SDI\No
18. GV2MAIN\PANEL WIDE PARAMETER\Enhanced Routing\RG1 Backup SDI\No
19. GV2MAIN\PANEL WIDE PARAMETER\Enhanced Routing\RG2 Primary SDI\No
20. GV2MAIN\PANEL WIDE PARAMETER\Enhanced Routing\RG2 Backup SDI\No
21. GV2MAIN\PANEL WIDE PARAMETER\Enhanced Routing\RG3 Primary SDI\No
22. GV2MAIN\PANEL WIDE PARAMETER\Enhanced Routing\RG3 Backup SDI\No
23. GV2MAIN\PANEL WIDE PARAMETER\Enhanced Routing\RG4 Primary SDI\No
24. GV2MAIN\PANEL WIDE PARAMETER\Enhanced Routing\RG4 Backup SDI\No
25. The control panel reset pin can be up or down.
26. The modem at the control panel location must be set for 9600 baud and echo off. This
information must be written to the modem configuration area. Hyperterminal can be used to
send the following Hayes modem commands (refer to the modem’s manual for command
syntax):
• ATS37=9 (set baud rate to 9600)
• ATE0 (eliminate echo)
• AT&W0 (write configuration to modem memory, not echoed)
27. Ensure that the modem at RPS is set up for 9600 baud.
28. From the control panel communication window on RPS, connect by modem at 9600 baud.