Filter
Top Products
D9412GV2/D7412GV2 | Program Entry Guide | 6.0 GV2AUX EN | 131
Bosch Security Systems, Inc. | 10/08 | F01U003636-04
5. Type [A][T][E][0][Enter]. This eliminates echo,
making all user input from this point forward
invisible on the screen.
When using an external modem, initialize
it using the following HyperTerminal
procedure on your computer. The
6. Type [A][T][&][W][0][Enter] to write the
configuration to modem memory. The modem
profile is saved to a file upon disconnection or
power loss.
HyperTerminal procedures can vary,
depending upon the operating system.
1. In Windows
®
, open the HyperTerminal
application. Select:
Programs→Accessories→Communications
The external modem is connected to the D9133DC
Direct Connect Programming Module that is
connected to the SDI bus using SDI Address 88.
Refer to
2. Connect the modem to an available COM port.
Figure 9 on page 132. A standard serial
cable is required to connect the D9133DC to the
external modem.
3. With the modem connected, select the
appropriate COM port within HyperTerminal.
Refer to
If you are using an external modem for
Figure 8.
RPS communications, the enhanced
4. Set the baud rate of the modem to 9600.
For Best Data Smart One V.92:
Type [A][T][S][3][7][=][9][Enter]
For US Robotics:
Type [A][T][&][N][6][Enter]
For other modems, consult the
instructions provided with the device for
the correct text string.
communications and RPS functions using
a NIM are disabled.
Figure 8: Com Port Selection within HyperTerminal