Page 864 of 894 QPC841 Quad Serial Data Interface card
553-3001-211 Standard 2.00 September 2004
Configuring the QSDI card
Configuring the QSDI card consists of setting these option switches for each
serial port:
• Port address
• Baud rate
• DTE/DCE mode
Figure 186 on page 868 shows the location of the option switches on the
QSDI card. Instructions for setting these switches are in the section that
follows.
Address switch settings
Table 270 on page 865 lists the address switch settings for the QPC841 Quad
Serial Data Interface card. The address select jumpers and logic on the card
address the UARTs using two pairs of addresses: 0 and 1, 2 and 3, through 15
and 16. The pairs do not need to be consecutive. Switch SW14 is used to
19 GND Ground Ground
21 CD Carrier detect (Note 1 Carrier detect (not used)
22 DTR Data terminal ready Data terminal ready (Note 2))
Note 1: In DTE mode, the signals CD, DSR, and CTS are tied to +12 volts (through a resistor)
to indicate that the QSDI port is always ready to transmit and receive data.
Note 2: In DCE mode, the signals DTR and RTS are tied to +12 volts (through a resistor) to
indicate that the QSDI port is always ready to transmit and receive data.
Table 269
Connector J2 pin assignments (Part 2 of 2)
Pin
Number
Port Signal Purpose in DTE mode Purpose in DCE mode